Booting the installer

Now you are ready to put the new disk into the CD drive and reboot your machine. This should present you with the friendly graphical screen for the Debian GNU/Linux installer that 64 Studio uses, and the boot prompt.

Press F1 for help, or ENTER to boot:

Unless you know you need special boot options hit enter and wait for the selection screen with the blue background to appear. If the CD doesn't boot, check your BIOS settings. You may need to change the boot order so that your computer attempts to boot from CDROM before the hard drive. Information on available boot methods and on boot parameters which might be useful can be found by pressing F2 through to F7. If you add any parameters to the boot command line, be sure to type the boot method (the default is install) and a space before the first parameter (e.g., install debconf/priority=medium).

Sometimes this part of the process can bring other hardware issues to light:

"...This didn't go at all smoothly, and I found my problems with my CD player were getting worse in a kind of randomly degenerating manner. I got so sick of listening to my CD player thrashing about and generally not doing as it was asked, The rather arcane error messages I'd been receiving didn't make an awful lot of sense, but it was clear that my CD player wasn't able to receive the control messages it needed, so I thought I'd take a peek inside the case (again) just to see if there was anything completely obvious that I'd missed.

I noticed that the Hard Drive and CD were plugged into the same IDE port, I mean I'd noticed it before and wondered why the other one didn't get used and assumed blondly that there must be some good reason. Well, I guessed it might not hurt if I tried plugging the CD player into the second one and Joy of Joys, my BIOS instantly recognises what I've done and prints an understandable message. Hooray!"

Selection of installation language

A stripped-down version of Linux is loaded into memory and various bits of information will scroll past the screen. You probably won't need to worry too much about these messages, unless your machine mysteriously fails during the process. Eventually you will be presented with a simple blue screen, from which the installer will prompt you for various bits of information:

  • Choose Language

  • Please choose the language used for the installation process.

  • Choose Country

  • Based on your language you are probably located in one of these countries or regions.

  • Choose Keyboard Layout

  • Select a keyboard layout

Activating the Ethernet network connection

Once you've chosen your language, the installer will scan your system for information about your hardware, check the CD for packages and load additional components to facilitate the next stage of installation. In this stage the installer attempts to find your network hardware and configure it using DHCP. If you do not have DHCP on your network, you can configure the network manually after installation (System > Administration > Network in the Gnome menu).

The installer will go on to detect your disks and other hardware.